产品结构树
  1. CAN/LIN  (88)
  2. 以太网  (79)
    1. 以太网 PHY  (41)
    2. 以太网重定时器、中继器和多路复用器缓冲器  (38)
  3. FPD-Link SerDes  (86)
    1. 摄像机 SerDes  (10)
    2. 显示 SerDes  (76)
  4. HDMI/DVI/DP/MIPI (CSI/DSI)  (48)
    1. 重定时器、均衡器和多路复用器/开关  (34)
    2. 桥接器和收发器  (14)
  5. I2C
    1. I2C 电平转换器、缓冲器和集线器  (19)
    2. I2C 通用 I/O (GPIO)  (30)
    3. I2C 开关和多路复用器  (10)
    4. I2C 键盘控制器和 LED 驱动器  (10)
  6. IO-Link/数字 IO  (8)
  7. LVDS/M-LVDS/PECL  (347)
    1. 缓冲器、驱动器/接收器和交叉点  (231)
    2. SerDes/信道链路  (116)
  8. 光纤网络 IC  (30)
    1. 激光驱动器  (12)
    2. CDR 和收发器  (2)
    3. 互阻抗放大器和限幅放大器  (16)
  9. PCIe/SAS/SATA  (42)
    1. 重定时器、转接驱动器和多路复用器/开关  (29)
    2. PCI/PCIe PHY 和桥接器  (13)
  10. RS-232  (129)
  11. RS-485/RS-422  (211)
  12. SDI  (65)
    1. SDI 电缆均衡器、驱动器、时钟恢复器和交叉点  (50)
    2. SDI SerDes  (10)
    3. SDI 视频定时  (5)
  13. UART  (29)
  14. USB  (108)
    1. USB Type-C 和电力输送  (35)
    2. USB 集线器  (17)
    3. USB 控制器和收发器  (14)
    4. USB 重定时器、转接驱动器和 USB/MHL 开关  (44)
  15. 更多接口  (103)
  16. 电路保护  (83)
    1. ESD 保护和 TVS 浪涌二极管  (50)
    2. 应用特定端口保护  (33)
  17. 工业收发器  (36)
  18. 开关和传感器监视器  (8)
  19. 电压电平转换  (135)
    1. 单向电压转换  (14)
    2. 双向电压转换  (25)
    3. 方向控制电压转换  (36)
    4. 逻辑电压转换  (26)
    5. 应用特定电压转换  (38)
  20. 隔离
    1. 数字隔离器  (160)
    2. 隔离式 RS-485 收发器  (10)
    3. 隔离式 CAN 收发器  (1)
    4. 隔离式 I2C  (4)
    5. 隔离式 LVDS  (3)
    6. 隔离式栅极驱动器  (24)
    7. 变压器驱动器  (4)
CAN/LIN Overview High-immunity, low-emissions, ESD-protected transceivers for harsh environments

3.3-Volt CAN transceivers

Industry-leading 3.3-V Vcc CAN transceivers are interoperable with 5-V mixed networks and offer a lower voltage and lower system cost alternative to 5-V transceivers

5-Volt CAN transceivers

Robust 5-V Vcc CAN transceivers with up to ±70V bus fault protection and up to ±30V of common mode voltage

Automotive CAN transceivers

High-immunity and low-emissions AEC-Q100 CAN transceivers with support for CAN FD (flexible data rate)

Isolated CAN transceivers

2.5-kVrms and 5-kVrms galvanically-isolated CAN transceivers with signaling rates up to 1 Mbps and –27 V to 40 V bus fault protection

Automotive LIN transceivers

High-immunity, low-emissions, AEC-Q100, single-wire robust communication transceivers for low-speed, short-distance automotive applications

System basis chip

Multi-function AEC-Q100 ICs integrating CAN and/or LIN transceivers with LDO regulators and additional features

Featured products

TCAN334

3.3-V CAN transceiver with small 3x3 mm package
  1. Download datasheet
  2. Order now
  3. Evaluation module
SN65HVDA100-Q1

SN65HVDA100-Q1

LIN 2.1 physical interface with dominant state timeout
  1. Download datasheet
  2. Order now
  3. Reference design

TCAN1042G-Q1

5-V CAN transceiver with 5-Mbps CAN FD support
  1. Download datasheet
  2. Order now
  3. Evaluation module

Technical resources

Training

Training
On-demand CAN and LIN training, including overviews and in-depth presentations. Watch and learn

Reference designs

Reference designs
Complete board-and system-level reference design circuits to help you quickly evaluate and customize your system. Search designs

Online support

Online support
Ask questions, share knowledge and help solve problems with fellow engineers in TI’s E2E™ Community Visit CAN/LIN forum

Blog posts

Blog posts
Read about a wide variety of CAN and LIN system design topics in TI’s blogs. Browse blog posts
Controller Area Network (CAN) is a robust multi master-master, differential signaling, serial communications bus specified by the ISO 11898 family of standards. TI’s industry-leading transceivers solve specialized networking requirements for various applications and power supply systems, providing solutions for 5 Volt and 3 Volt operation as well as CAN FD (Flexible Data rates) and up to ±70-V Bus Fault Protection; simplifying complex CAN bus networked systems. TI CAN transceivers also support higher layer protocols such as CANopen (EN 50325-4), DeviceNet, SAEJ1939, ISO11783, and many others. TI also has a wide offering of Local Interconnect Network (LIN) transceivers which support standards such as ISO/DIS 17987, LIN 2.1, LIN 2.2A, Most ECL, SAEJ2602 and ISO9141 (K-Line) for both 12-V battery and 24-V battery systems. The devices are up to 100-kbps receive capable for node programming devices and include optional features LIN Dominant State Timeout and up to ±58-V Bus Fault Protection.
 
鸿运国际网址